5
4
Specifications
illus.-1.1
Typical Installation
Installation
Contents
Installation Considerations
Before beginning any installation, follow these simple rules:
1. Be sure to carefully read and understand the instructions before
attempting to install these speakers.
2. For safety, disconnect the negative lead from the battery prior to
beginning the installation.
3. For easier assembly, we suggest you run all wires prior to mounting
your speakers in place.
4. Use high quality connectors for a reliable installation and to minimize
signal or power loss.
5. Think before you drill! Be careful not to cut or drill into gas tanks, fuel
lines, brake or hydraulic lines, vacuum lines or electrical wiring when
working on any vehicle. If installation in a boat, take care not to cut or
drill through the main hull.
6. Never run wires underneath the vehicle. Running the wires inside the
vehicle or hull area provides the best protection.
7. Avoid running wires over or through sharp edges. Use rubber or
plastic grommets to protect any wires routed through metal, especially
the firewall.
Mounting
1. Determine where the speakers will be mounted. Be sure that the
mounting location has sufficient clearance in all direction for the
speaker to swivel; conduct a full rotation to ensure there is not
obstruction.
2. Mark the locations on the underside of the mounting surface for the
speaker mount and wire harness. Drill 5/16” holes for the mounting
bolts and a 7/16” for the wire harness. If you want to surface mount
the wiring, use the notch provided in the mount instead of drilling
the hole.
3. Insert the supplied grommet and feed the wire harness through.
Be sure to observe proper polarity when connecting the wires. The
speaker harness’s negative wire is indicated with a “black stripe”.
4. Feed the speaker harness through the mount. Using the supplied
hardware, through bolt and tighten the mount securing it. Be sure to
connect the safety lanyard to the mount during this process.
5. Using the security torx bolt, slide the speaker enclosure onto the
mount and tighten. Connect the other end of the safety lanyard to the
security torx prior to tightening.
6. To swivel speaker, loosen security torx until speaker can swivel freely.
Be sure to tighten once desired position is achieved.
Note: For tubular mounting applications, a Tower Speaker Clamp will be
required. (PM-CL1/PM-CL1B)
illus.-2.1
• (2) Marine Grade Speakers
• (2) Mounting Couplers
• (2) Molex Speaker Harnesses
• (2) Wire Grommets
• (1) Security Torx Wrench
• (2) Security Torx Bolts
• (4) Mounting Bolts
• (4) Mounting Bolt Nuts
• (2) Safety Lanyards
• (2) Layard Washers
PM282HW/PM282HW-B
PM282W/PM282W-B
7.8” Dia
(197mm)
1.7”
(44mm)
0.6”
(16mm)
14.2”
(360mm)
8.3”
(211mm)
6.8”
(174mm)
3.3”
(84mm)
2.5”
(64mm)
10.9”
(277mm)
5.9”
(150mm)
9.1”
(230mm)
37.5°
52.5°
7.8” Dia
(197mm)
14.2”
(360mm)
8.3”
(211mm)
6.8”
(174mm)
10.9”
(277mm)
5.9”
(150mm)
9.1”
(230mm)
37.5°
52.5°