Rockford Fosgate Power Elite T4004, Руководство по установке, Страница: 4 / 72

1.
Power LED (Top of unit - Not Shown)
– This Blue LED illuminates when the unit is turned on.
2.
Thermal LED (Top of unit - Not Shown)
– This Red LED illuminates if the amplifier reaches the
third stage of thermal protection.The amplifier will shut down to cool if this occurs.
3.
Protect LED (Top of unit - Not Shown)
– This Yellow LED illuminates if a short circuit or too low of
an impedance is detected at the speaker connections.The amplifier will automatically shut down if this
occurs.
4.
Cast Aluminum Heatsink
– The cast aluminum heatsink of the Power amplifier dissipates heat
generated by the amplifier's circuitry.
5.
Speaker Terminals
– The heavy duty, nickel-plated clamp wire connectors (
+
and
-
) will accept wire
sizes from 8 AWG to 18 AWG.
6.
Remote Bass
– The Para-Punch Remote Bass connection is made with a RJ-45 cable and can be installed
in a variety of ways for easy control access. One control is used to boost low frequency information to
overcome road noise and put the
bass in your face
.This Bass control is a narrow band adjustment
variable from 0dB to +18dB with a Gyrator based Punch EQ that eliminates frequency shift with boost.
The other control is used for adjusting center frequency variable from 35Hz to 70Hz.
7.
Gain Control
– The input gain control is preset to match the output of most source units. It can be
adjusted to match output levels from a variety of source units.
8.
Variable Crossover
– Is a built-in 12dB/octave Butterworth filter selectable for High-Pass (HP),All Pass
(AP), or Low-Pass (LP) operation variable from 40Hz to 400Hz.
9.
RCA Input Jacks
– The industry standard RCA jacks provide an easy connection for signal level input.
They are nickel-plated to resist the signal degradation caused by corrosion.
10.
RCA Active Pass-Thru Jacks
– This Active Pass-Thru provides a convenient source for daisy-chaining
an additional amplifier without running an extra set of RCA cables from the front of the vehicle to the
rear amplifier location.
11.
REM Terminal
– The heavy duty, nickel-plated captive c-clamp wire connector will accept wire sizes
from 12 AWG to 24 AWG.This terminal is used to remotely turn-on and turn-off the amplifier when
+12V DC is applied.
12.
Power Terminals
– The power and ground are nickel-plated captive c-clamp wire connectors and will
accommodate up to 4 AWG wire.
13.
Fuses
– These ATC fuses are easily accessible in case of failure.Always replace fuses with same type and
rating. See Specifications for fuse ratings.
14.
2/4 Channel Switch (T4004 only)
– Pressing this switch in, switches the inputs to a 2-channel
mode, allowing connection to only the front inputs with a 4-channel output.
4
D
ESIGN
F
EATURES