big tooth
small tooth
Don’t unscrew the strain relief. Twist the whole connector, not
just the blue part
RECTIFIER CABLE
ROUND CONNECTOR
GENERATOR WHEEL
BIKE INPUT SOCKET
CONNECT TO
circuit box
CONNECT TO
GENERATOR
WHEEL
strain relief
thumb tab
The Rectifier Cable connects the Generator Wheel to the circuit box.
HOW TO DISCONNECT THE ROUND CONNECTOR:
1.
Slide the thumb tab back toward the cable.
2.
Twist the connector 1/8 of a turn counter-clockwise, then pull.
1. Join the cables’ flat connectors. If they don’t snap in, flip one
side over and retry.
2. On the right side of the circuit box is a black socket labeled
Bike
Input.
Insert the round connector with a push-and-twist motion.
CONNECTING GENERATOR WHEEL
activity TIPS
LED TOWER SOCKET
activity tips
8
As you pedal vigorously, a small
light inside the circuit box will turn
on. Next, the red panel will light up,
followed by blue and green.
3. Light up all three stages and main-
tain them for a few seconds. The
panels will flash in sequence to
indiate a win on easy mode.
4. As the circuit resets following this
win, all LED panels and halogen
bulbs should light up. Watch to see
that all lights are in working order.
An adjustable difficulty knob controls the five levels of resistence.
Easier modes offer less resistence, require less effort, and cannot
light the halogen bulbs on top of the green panel. Harder modes
can light the bulbs, and will challenge even strong cyclists.
1. Turn the difficulty knob to its easiest setting.
2. Get on the bike and pedal gently at first, then increase speed.
CONNECTING TOWER
TESTING THE SYSTEM
9
On the left side of the circuit box is a larger silver socket labeled
LED Tower.
Attach the cable on the red panel by inserting the large
round connector with a push-and-twist motion.