Roche OMNI C, Инструкция по эксплуатации

Страница: 96 / 152

6 Maintenance
6-2
Instructions for Use, Roche OMNI C, Rev. 4.0, December 2002
Surfaces of the instrument
See section Surfaces, page 6-20 !
Tubing paths
Press:
> System > Wash & clean > Decontaminate all tubes
Follow the instructions on the screen.
• Open the bottle compartment cover and remove bottles C1, C2, C3.
•
Fill the shutdown kit about halfway with deproteinizer.
• Insert the shutdown kit into space C3.
• Connect the tubes of the set with the connectors from C1 and C2 (Fig. 1).
Fig. 1
• Press the button to begin decontaminating the tubes.
• Remove the shutdown kit.
TIP: Remove the remaining fluid from the tubes by briefly holding the tubes vertically,
allowing the fluid to run back into the container.
• Empty the container according to local regulations and fill the shutdown kit halfway
with distilled water.
• Replace the shutdown kit to the position of C3.
• Connect the tubes of the set with the connectors from C1 and C2 (Fig. 1).
•
Press the button to begin cleaning the tubes.
• Remove the shutdown kit.
TIP: Remove the remaining fluid from the tubes by briefly holding the tubes vertically,
allowing the fluid to run back into the container.
• Press the button to begin emptying the tubes.
• Re-insert the bottles C1, C2, and C3 [see section Exchanging the solutions C1 calibra-
tion solution 1, C2 calibration solution 2, and C3 fluid packs, page 6-7 ].
• Close the bottle compartment cover.