Roche OMNI C, Инструкция по эксплуатации

Страница: 109 / 152

6 Maintenance
Instructions for Use, Roche OMNI C, Rev. 4.0, December 2002
6-15
• Open the flap to the labelled capillary position (completely open position).
• Remove the sample drop cup and clean it according to local regulations (see Fig. 17/1).
• Open the bottle compartment cover.
• Remove the red tube connector from the wash plate (see Fig. 17/2)
•
Push the wash plate down (to unlock) and pull it out (see Fig. 17/3). The wash plate is
locked when the plug is sticking out and cannot be removed.
Fig. 17
• It is best to clean the wash plate under running water. Then, dry well.
• Then push the wash plate back in completely and attach the tube plug.
• Push the sample drip tray in.
• Close the flap.
• Close the bottle compartment cover.
6.6.3 Replacing printer paper
TIP: The printer paper is heat sensitive on one side only. Please make sure that you insert
the paper roll correctly.
•
Open the printer cover.
• Remove the empty cardboard roll.
• Cut off, at a right angle, the start of the paper.
• Place the new paper roll into the holder.
• Make sure that the printer lever is in the "down" position (see Fig. 18).
• Feed in the beginning of the paper according to the sticker on the inside of the printer
cover (see Fig. 18).
Fig. 18
(1)
(2)
(3)
printer lever