Roca MULTICLEAN A804006001, Руководство пользователя, Страница: 16 / 30

14
English
Español
Deutsch
Italiano
Français
Português
Troubleshooting
Issue Possible
No working
1. Disconnected/ no power supply
2. No electrical power supply
3. Product is power off.
1. Connect the product
2. Check there’s a 220-240V~ signal with another
product (such us hairdryer)
3. Push the power button (on/off auxiliary control).
Low water flow or pressure
1. Clogged filter
2. Twisted hose
3. Nozzle cap is stuck 1. Clean water filter (page 12)
2. Straighten the hose
3. Clean nozzle cap (page 11)
Nozzles do not function properly
1. Nozzles are dirty
2. Clogged filter
3. Water pressure is too low 1. Clean the nozzles (page 11)
2. Clean the filters (page 12)
3. Adjust water pressure
Washing feature does not work
or fails to spray
User not properly seated Adjust your sitting position
Product shuts off during use
1. Washing time exceeded 5
minutes
2. Power failure
1. Repeat Cleaning function
2. Check power or unplug the cord to reset
Seat not heated Seat temperature set to off Reset heated seat temperature (page 8)
Water not heated Water temperature set to off Reset water temperature (page 6)
Dryer not working Dryer only operates when activated Sit on product to operate dryer
Remote control is failed to be
operated. Battery is low power.
(low power battery warning display)
Replace the battery. (page 11)
Seat sensor LED is blinking on the
auxiliary control panel.
Dryer sensor error signal.
Unplug and wait for 20s and connect again the product
to power supply.
Seat heater LED is blinking in green
on the auxiliary control panel.
Seat temperature error signal.
Unplug and wait for 20s and connect again the product
to power supply.
Seat heater LED is blinking in red on
the auxiliary control panel.
Water temperature error signal.
1. Set temperature setting at OFF and activate clean
function or nozzle clean function and gradually set
again the temperature for self learning.
2. Unplug and wait for 20s and connect again the
product to power supply.
Power LED is blinking on the
auxiliary control panel.
Lack of water into the tank.
1. Clean water filter (page 13)
2. Validate water inlet flow and pressure it's enough.
3. Unplug and wait for 20s and connect again the
product to power supply.
Power saving LED is blinking on the
auxiliary control panel.
Clean water error signal.
1. Clean water filter (page 13)
2. Validate water inlet flow and pressure it's enough.
3. Unplug and wait for 20s and connect again the
product to power supply.