Robustel GoFixed W800 User Guide
RT_W800_UG_v02.00
04.11.2011
Page 46 /59
Confidential
To enable remote access to the GATEWAY web interface and check the Enable box under WAN for the HTTP service.
The default port is the standard web port 80 which can be changed by entering a new value under WAN Port.
Once enabled, it will be possible to access the web interface by browsing to the Internet IP Address assigned to the
GATEWAY. For example, if the IP address assigned by the ISP is 80.70.60.50 and the WAN Port is set to 8080 the
following would be entered into the web browser: http://80.70.60.50:8080
Note:
It is strongly recommended that the web interface password be changed (go to path Tools -‐> Access Control)
before enabling the Access Control feature.
This feature can be used via an ADSL or 3G connection. Note that some 3G networks have internal NAT and Firewall
systems which do not allow remote access.
3.11
Voice
3.11.1 Voice Configuration
Connect a normal analogue telephone to the Phone port.
Phone calls can be made over the GSM/3G network (when a valid SIM is inserted) and using Voice over IP (when
there is an active connection to the internet).
By default, all calls are dialed over the GSM/3G network. To make calls via VoIP (SIP) it is necessary to configure a
connection to a SIP Service Provider:
3.11.2 Basic Settings
Go to path:
VoIP -‐> Basic Settings
page, then click on the Service Provider 0 tab.
Enter SIP parameters and click Apply to save the parameters.
