Robur Calorio Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 24 / 44

Sezione installatore idraulico
23
3.3 SEQUENCE OF INSTALLATION
With reference to the installation project, prepare gas supply and electrical supply lines
and holes for exhaust outlet and intake air for combustion.
INSTALL THE CONVECTOR ON THE WALL
1. Before unpacking the unit check that the external packaging is in good condition and
that no damage has occurred during transportation, if so promptly contact your
supplier
2. Unpack the unit from its protection wrapping, slip off the inlet and outlet flues first.
DO NOT THROW AWAY THE TEMPLATE where a drilling guide for the correct
installation of the unit is given.
3. Fix the template to the wall where the unit is to be installed making sure it is
perpendicular to the floor.
4. Drill a hole (Ø 50 mm) to locate the main pipe as well as the A holes (see, Figure 8)
to fix the support bracket (drill 6 mm holes for the insertion of the support frame).
The Ø 50 mm hole for the type of installation described here above can be realised
by a rotary cutter (see Section accessoriy) or smaller holes realised by a simple
drilling machine on the perimeter.
5. Adapt the length of the pipes (exhaust outlet and intake air) to the effective depth of
the wall, cutting the exceeding part: for the exact length see Figure 7.
In the Ø 49 pipe do not cut the side with the edging that will be used for fixing the
pipe.
In the Ø 35 pipe do not cut the side with a skirted end that will be necessary to
connect the pipe to the unit.
6. Remove the template from the wall.
Figure 7 –
Information about air/flue pipes cutting