
4
Chapter 1 Getting Started: Setup and How to Operate the Robot
SETUP AND HOW TO OPERATE
Step # 1 Read the manual
For connecting the wiring, follow the letters and description labels on the wiring and
components of the system.
Step # 2 Attach the Smoke Alarm on the base unit
The Smoke Alarm usually comes attached to the base unit already. If you need to connect it,
this is how.
1. Connect the Smoke Alarm control wires to the base unit. These are two wires coming up
through the hole on the base. Match these wires with the same colors coming out of the
Smoke Alarm. One is Blue/Orange/Yellow and the other is Green/White.
2. Set the Smoke Alarm in position over the holes in the base.
3. With the Smoke Alarm in position on top of the base unit, Screw the two screw knobs into
the bottom of the Alarm to secure it.
Note: If you have the
Smoke Alarm Standard Model,
you can go to step 4
powering up
and
step 5
running Buzz on automatic mode
.
Step # 3 Fold out the House of Hazards
1. Open the two side latches and open the House on a table.
2. Remove the front panels by lifting up to clear the bottom metal catches and then pull the
bottom out. To install the panels put the top up and in first and then lower the bottom metal
catches in at the bottom. You can see the slots in the plastic at the bottom of the opening.
3. Install the chimney on the top of the House.
Connecting the extension wires (depends on the package that you have)
1. Smoke Alarm only- no extension cables are needed.
2. Smoke Alarm and controls only- One extension cable from the control box to base unit.
3. Smoke Alarm and House- Connect the extension cable from the base unit to the House in
the back.
4. Smoke Alarm, House and Controls- Two extension cables are used; base to House and
control box to base unit.
Step # 4 Powering Up
1. Connect the power supply Red/Black wire to the Red/Black connector on the back of the
base unit.
2. Connect the power supply AC cord to a 110 Volt AC outlet.
3. Turn the power supply on.
4. When you are ready to turn it on, turn on the switch at the back of the Smoke Alarm base
unit. This powers up the entire system.
Step # 5 Running the Smoke Alarm and House on Automatic Mode:
1. Connect the MP3 player audio cable.
Models with a control box: Connect to the audio jack of the control box (Velcro on box).
Models w/out a control box: Connect to the audio jack on the base unit (Velcro on base).
2. Insert the programmed CD into the CD player or turn on the MP3 player.
3. To run the House on automatic mode, press play on the CD/MP3 player.
4. The House and Smoke Alarm will go through a program of songs. You can run it from one
track to the next continuously or you can select tracks.
Содержание Buzz E. Smoke Alarm & Safety House
