PAIRING PROCEDURE
To add a remote or wall switch or the Soft button (EnOcean
compatible) you must enter the pairing mode, your light must
be switched OFF. Relay must be power supplied.
Two modes
1.
From the Relay Switch
Launch the pairing by doing 3 consecutive presses on the relay
switch button. The LED blinks red.
NOTE:
if the LED blinks orange during the pairing procedure, it means
that more than 22 controllers are paired. You must remove one
controller to add a new one.
2.
From the wired wall switch
Do 3 times the cycle »down-stop« with the wired wall switch.
The roller shutter/awning will rise of 10%.
The roller shutter/awning confirms the pairing by closing
complitely.
UNPAIRING PROCEDURE
Do the same procedure as pairing and takes care of pressing the
button previosly chosen to define the state »up« of your roller
shutter/awning.
RESET PROCEDURE
Relay switch must be power supplied.
1.
Press more than 5 seconds on your module`s button. The
LED blinks orange.
2.
Press once again the button (short press) to confirm the
reset. If the reset is correct the LED blinks alternatively in
red and green and stays green. Start again if necessary.
3.
Your module has now its original settings.
You have now 30 seconds to pair your controller by briefly
pressing on the button of your choice, this one will control
the rise of your roller shutter/awning.
You have now 30 seconds
to pair your Soft button by
doing 5 brief consecutive
presses on the button.
The LED of the relay
switch will blink green
twice, confirming the
pairing.
Put the roller
shutter/awning in
position up.
You have now 30 seconds to pair your controller by briefly
pressing on the button of your choice, this one will control
the rise of your roller shutter/awning.
