Robot X5 CVABR-H221, Руководство пользователя, Страница: 7 / 12

Before Using
►
The robot shall always connect power cable for normal using.
►
How to put the robot onto glass to start using?
(1) Turn on power-switch, and then make sure the fan is running.
(2) Put device onto glass and keep 10cm away from the window frame.
(3) Check if device can stick to the glass before releasing it.
►
How to take device down from glass?
(1) While device is running, please hold safety rope with one hand and take device down
from glass with the other hand.
(2) Turn off power-switch in safe area.
►
Safety rope and buckle
(1) Before using, check if the safety rope is broken or the knot is loose.
(2) Fasten the safety rope and tie to indoor fixture before operating.
►
UPS (Un-interrupted Power System) function
(1) The UPS function will be enabled automatically when no electric power supplied. The
backup time of this UPS is
30
minutes.
(2) If no electric power is supplied, the device will stop automatically, alert and flash red
lamp. User shall take device down from the glass as soon as possible.
(3) User can pull device back by pulling safety rope. Slightly pull the safety rope at an
angle close to the glass to prevent dropping.
►
Please make sure the battery was full-charged (green lamp ON) before using
(1) First, turn off the power-switch on the device. Plug in the power. Orange lamp ON
means charging.
(2) Green lamp ON means the battery was full-charged.
►
Table cleaning mode
Put device on the table and select auto-cleaning mode, the device will run in
table-cleaning mode.
►
Notice
(1) Do not use it on frameless glass.
(2) Make sure put cleaning ring onto cleaning wheel correctly for no leakage.
(3) Do not use it in rainy or moist day.
(4) Set danger-warning area downstairs for no-balcony window and door.
How to Clean the Glass
Step I: Use ONLY clean-and-dry cleaning cloth to clean dust and sand on the glass.
Step II: Change again the cleaning cloth. Keep upper wheel’s cleaning cloth as
clean-and-dry. Spray a little detergent (1~2 spray) on lower wheel’s cleaning cloth, but
not make cloth wet (if too wet, the machine can’t move well). Then clean the glass again.
6