Robopac ROTOPLAT 108-308-508-708, Руководство по эксплуатации и обслуживанию

Страница: 104 / 121

ENG MAINTENANCE INFORMATION
104
7.2. PERIODICAL MAINTENANCE INTERVALS
Important
Keep the machine in maximum efficiency conditions and perform all the scheduled maintenance
operations provided for by the Manufacturer.
Proper maintenance will provide the best performance, a longer life span and constant compliance with
safety requirements.
Maintenance interval table
Frequency Component Type of intervention Intervention mode Reference
Every 40 hours or
1000 cycles (*)
Machine Cleaning cloth or
air blow
-
Air filter unit Condensate
drainage
- See “Condensate
drainage”
Filter cleaning Clean with an air jet
and alcohol
See “Cleaning the
air filter”
Every 200 hours or
5000 cycles (*)
Rubber rollers Cleaning Clean with alcohol -
Lifting chains Greasing - See “Lubrication
point diagram”
Tensioning check Adjust See “Spool carriage
lifting chain
adjustment”
Table rotation
chain
Greasing - See “Lubrication
point diagram”
Tensioning check Adjust See “Rotary table
chain adjustment”
Reduction units
and gearmotors
Checking lubricant
level
1
Top up, if necessary,
with lubricant of the
same type
See lubricant table
Gear wheels of
carriage pre-
stretch gears
Greasing - See “Lubrication
point diagram”
Every 2000 hours or
10000 cycles (*)
Lifting chains Wear check - -
Safety devices Efficiency check - -
Table rotation
chain
Wear check -
Every 5000 hours or
50000 cycles (*)
Rotary table
wheels
Replacement - See “Replacing the
rotary table wheels”
Carriage lifting
wheels
Replacement - -
Reduction units
and gearmotors
Lubricant change
1
Use lubricant with the
same characteristics
See lubricant table