Robland E - 45, Инструкция по эксплуатации

Страница: 12 / 35

Use and adjustment of the riving knife
(fig, 8)
The machine is equipped with riving knives for the use of sawblades from 250 to 300 mm, and for
350 to 450 mm diameter.
The riving knife has to be adjusted in such a way that over its entire length the gap between sawblade
and riving knife does not exeed min.3 mm and max. 8 mm.
The riving knife can be adjusted in both vertical and horizontal direction.
The height setting has to be adjusted in such a way that the highest point of the riving knife never exeeds
more than 3 mm above the highest placed sawblade tooth.
After height adjustment always lock the central bolt (3). The three little adjustment screws (2) are
used for the exact setting of riving knife in line with the sawblade.
For slotting or grooving the riving knife has to be adjusted in such a way that the upper part of the riving
knife is never set lower than the highest saw tooth in use.
NEVER REMOVE THE RIVING KNIFE, KICKBACKS CAN KILL !!
Sliding table lock (fig, 9)
When loading the workpiece onto the table, and when ripping along the parallel fence the sliding
table should be locked in place.
To achieve this, simply push the sliding table to the far end against the stop, and lift lever (2) and
push it into the opening at the side of the table.
Mounting of the cross-cut fence
(fig, 10, 10 bis)
- The cross-cut table has four precision bores allowing the fence to be put in 2 positions: at the
back side and at the front side of the cross-cut table.
- Put the fence onto the the cross-cut table and lock it in position using the two serrated nuts (3).
- The 90° right angle of the fence is factory set. Should the 90° angle need to be adjusted, then the
two bolts (fig, 10 bis,2) must be loosened: then by turning the little bolt (fig, 10 bis,1), the angle
can be opened or closed towards the sawblade.
- After adjustment the 2 bolts (fig, 10 bis,2) have to be retightened.