3
Pre-installation
Thank you for purchasing a quality Robinhood rangehood. Robinhood has a high standard of quality control
and every range hood is tested and approved before it leaves the factory.
Important:
Please read the entire instructions before installing the rangehood. Check appliance for damage or
missing parts (if damaged, do not install).
Always switch power off prior to installation.
All electrical work must be done in accordance with local and national electrical codes as applicable.
For safety, this product must be earthed.
A power outlet should be within 1m of the power cord exit from the rangehood.
The socket must be accessible and enable the end user to isolate the rangehood from the power for the
purpose of internal cleaning or maintenance.
Stainless steel or powder coat is very easily damaged during installation if abraded or knocked by tools.
Protect the rangehood with the cardboard box or plastic bag during installation.
All ducting must comply with local requirements and building codes.
Suitable fixings will be required to mount this rangehood.
See Ducting options next page.
600mm rangehood are for 600mm hobs, 900mm rangehoods are for 900mm hobs.
The minimum distance between an electric or gas hob surface and the lowest part of the rangehood is
650mm. If the instructions for the hob specify a greater distance, this has to be taken into account.
Stainless steel is very easily damaged during installation if abraded or knocked by tools. Protect the
rangehood with the cardboard box or plastic bag during installation.
Contents of packaging:
1 x rangehood (2/3 Filters)
1 x Ø150mm outlet adaptor (attached)
1 x Chimney
1 x Ø150mm Flexible Tubing
6 x Wall Plugs
6 x M5x40mm Screw
2 x 7mm Screw
2 x 4mm Screw
Typical equipment required:
o
electric drill
o
screwdriver
o
tape measure
o
spirit level
o
duct tape
o
jig saw and ladder
