Robin EH09D, Руководство по обслуживанию, Страница: 69 / 84

- 65 -
(5) Setting the rope. (2 persons required)
-1 : Set the end of the rope through the rope
guide and the rope hole of the reel and pull
the end about 20 cm out of the reel.
(Fig. 9-7)
-2 : Fasten the end of the rope.
Fig. 9-8
-3 : Put the rope into the reel, whereby make
sure that the rope will not float up.
(Fig. 9-9)
-4 : Hold the rope firmly with one hand at the
position about 50 cm from the rope guide
and keep the rope slightly pulled so that
the rope will not be wound in.
-5 : Take your hand off the reel gently and re-
lease the rope slowly checking the wind-
ing power of the spring until the knob
reaches the rope guide.
Assembly is complete.
Fig. 9-9
ABOUT
20mm
(6) Test the operation of the recoil starter to see if the rope recoils satisfactorily and the ratchets extend
and retract properly. Mount the recoil starter to the engine.
(7) If the spring escapes from the reel when disassembling the recoil, hook the outer end of the spring
onto the notch of the reel and rewind the spring into the housing.
(8) Lubricate the rotating parts, sliding parts and spring with heat resistant grease before reassembling
the recoil and prior to long term storage.