Each Lap Counter registers up to 999 readings and appears on the left side of the row of digits with the
brackets below. The brackets below the Lap Counter will flash once per second when the timer is running.
The brackets will not flash when the timer is stopped or reset to all zeros.
“SEPARATE” or “ALL” Starts: During the Chronograph and Speed Timer Set-up modes, you may
choose to start the timers independently (“SEP”) or simultaneously (“ALL”).
Choosing “SEP” allows you to start each timer on its own, as necessary (i.e., a staggered start). Choosing
“ALL” starts each timer at the same time. The “SEP” indicator will appear below the lower row of digits
when chosen. Should the “SEP” indicator not appear, then the timers will start together.
PART IV. CHRONOGRAPH (STOPWATCH) OPERATION
From NORMAL TIME, press (E), “Chrono” prompt appears for two (2) seconds. After the “Chrono”
prompt disappears, the SC-888 should be in the reset (all zeros) position.
NOTE: You cannot operate the Chronograph unless the Speed Timer is reset to all zeros. (refer to Part V
“Operating the Speed Timer”.) The Chronograph resolution is 1/100 second for the first 60 minutes, after
which it changes to one (1) second.
How to Set-Up the Chronograph
A Chronograph (stopwatch) times events with a high degree of precision by counting up. Prior to starting
the chronograph, please refer to Part III, above, to review the various options available in setting up
(configuring) your SC-888 Chronograph. Select the desired option when it appears flashing.
From the Reset position, press and hold (F) for three (3) seconds, “LAP:SPL” appears in the top row of the
display with “LAP” flashing. Press (C) to select LAP or SPL (split) timing function.
Then, press (E). “ch-1 2 3” appears in the middle row. Select from: Single “1”, Double “2” or Triple “3”
Chrono by pressing (C).
Press (E) again. “SEP:ALL” appears in the bottom row. Select from “SEP” (all chronographs start
independently) or “ALL” (all chronographs start simultaneously) by pressing (C). “SEP” or “ALL”
selection only affects Double “2” or Triple “3” Chronographs.
After selecting the Chronograph configuration best suited for your use, press (F) to exit the set-up
procedure.
Memory Recall Direction
With the Chronograph in the Reset (all zeros) position, press (F) to select between memory recall in
UP/Ascending (1,2,3 . . . 149, 150) or DOWN/Descending (150, 149 , 148 . . . 3,2,1) order.
The recall direction indicators are located above the lap counter in the top row of the display on the far left.
UP/ascending “
⇑
” or DOWN/descending “
⇓
”. The memory recall direction cannot be changed if the
chronograph is active (“RUN” indicator appears) or stopped, but not reset to all zeros.
IMPORTANT
:
Pressing and holding (F) to enter the set-up procedure will automatically change the recall direction. Please
check the recall direction after set-up, to ensure it is correct for your use.
Chronograph Set-Up Confirmation and Indicators
