5
Using your clock radio for the
fi
rst time
1. Place your clock radio on a
fl
at surface.
2. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the clock radio.
3. Insert the adaptor plug into the DC Input socket located on the rear
of your clock radio.
4. Plug the adaptor into a standard 13amp mains socket outlet.
IMPORTANT:
The mains adaptor is used as the means of connecting
the clock radio to the mains supply. The mains socket used for the clock
radio must remain accessible during normal use. In order to disconnect
the clock radio from the mains completely, the mains adaptor should
be removed from the mains socket outlet completely.
5. When your clock radio is
fi
rst switched on the display will show
'Setting
Clock'
and a station search will be performed automatically.
6. When a signal has been found, the clock information will appear on
the display. Press the
Display
button to toggle between showing the
time only or showing both the date and time.
7. If no signals are found
'Clock not set'
will be displayed. It may then
be necessary to relocate your clock radio to a position giving better
reception. You should then carry out an auto scan to
fi
nd stations as
described on page 9.
AUX IN
DC IN
