7
Assembling the turntable (part 2)
1. Unpack the platter and identify the drive belt.
2. Place the platter on the spindle. Use one of the holes in the platter to
access the drive belt and place it over the pulley of the drive motor.
3. Slowly rotate the platter by hand to ensure that it moves freely and
that the belt is not twisted.
4. Place the rubber mat on the platter.
5. Fit the two hinges onto the top cover. Note that the hinges are sprung
and will tend to spring away from the cover.
6. Locate the other end of the hinges in the two sockets at the rear of
the turntable base.
7. Lower the cover into place over the platter and tone-arm.
Drive
belt
Underside of
the platter
Drive belt
Platter
Access hole
in the platter
Hinges
Cover
Hinges
Sockets
Cover
Motor pulley
