10
Listening to the Radio
1.
Switch on your radio by pressing the Radio On button.
2.
The backlight will change from green to orange. The radio icon and
the station frequency will show in the display. After approximately 10
seconds the display will revert back to showing the time.
3.
The current waveband is displayed at the top of the display. To set a
radio band (FM or MW), press and release the Radio Band button
until the required band is shown.
4.
Tune in to the desired station by pressing the Tuning Up or Tuning
Down buttons. The station frequency is indicated in the display.
To tune to a station automatically, press and hold the Tuning Up or
Tuning Down buttons until the required station frequency flashes in
the display.
The Wire aerial located on the rear of your CD clock radio is for FM
reception. The wire should be fully extended and positioned for
optimum reception.
For MW reception there is a built in ferrite aerial. Rotate your CD
clock radio to the position giving best reception.
5.
Adjust the volume by rotating the Volume control.
6.
When the selected band is FM and the station being received is an
FM Stereo station the stereo icon will show in the display,
otherwise the mono icon will be displayed.
7.
Press the Display button at any time to switch between clock and
radio displays.
8.
The radio can be switched off by pressing the Stop/Off button on the
top of the unit. The backlight will return to green and the clock display
will show.
1
4
4
5
3
7
8
cr9980 instruction book1.PMD
1/14/2005, 12:36 PM
10
