If you need any further advice, please
call our Technical Helpline on
0181 758 0338 (Mon-Fri)
4
General
Do not allow this unit to be exposed to water or steam. Do not leave the unit
where excessive heat could cause damage. It is recommended that the
FM band be used wherever possible as better results in terms of quality and
freedom from interference will usually be obtained than on the MW band.
Mains supply
The CR960 will operate from a supply of AC 230 volts, 50Hz
only.
For your convenience this product is supplied with a plug which is fitted
with a fuse of the appropriate rating. If the plug supplied is not suitable for
your socket outlet, it should be removed by unscrewing the plug top, the
terminal screws, and removing the cable.
The correct style of plug to suit your household together with a correctly
rated fuse should be fitted.
IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN
IMPORTANT. DO NOT
make any connection to the larger terminal which
is marked with the letter E or by the safety earth symbol
or coloured
Green or Green-and-yellow.
The wires in the mains lead are coloured in accordance with the following
codes :-
BLUE - NEUTRAL BROWN - LIVE
As these colours may not correspond with the coloured markings identify-
ing the terminals in your plug, proceed as follows:
The wire coloured BLUE must be connected to the terminal marked N or
coloured BLACK.
The wire coloured BROWN must be connected to the terminal marked L or
coloured RED.
Fuse
This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug
(BS1363). If another type of plug is used a 5A fuse should be fitted in the
plug, adaptor or distribution board.
IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN.
Back-up Battery
Slide the battery cover catch (23) in the direction of the arrow. Remove the
battery cover. Fit a 9 volt IEC size 6F22 (6LR61, PP3) or equivalent battery
into the compartment. Replace the battery cover. The time and alarm
settings will be retained during a temporary failure of the AC mains supply.
The LED display will not be operational. The battery is not necessary for
the unit to function.
Setting the time
Press and hold down the time set button (22). Use the time adjust buttons
(18-21) to adjust the time to the required setting:
(18)
S.FWD Clock time slow forward.
(19)
F.FWD Clock time fast forward.
(20)
F.REV Clock time fast reverse.
(21)
S.REV Clock time slow reverse.
Release the time adjust button followed by the time set button when the
required time is reached.
Note:
The clock uses a 12 hour display with a PM indicator (5). Ensure that the
correct 12 hour cycle is selected.
Alarms
The CR960 has two alarms which can be set and activated independently.
Each alarm can be set to the HWS (Humane Wake System) buzzer or radio
alarm.
e.g. Alarm 1 could be set to HWS buzzer for 8:00 AM, Alarm 2 set to Radio
for 8:30 AM.
