Roberts Gorden Corayvac CRV-B Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 28 / 96

CRV-S
ERIES
I
NSTALLATION
, O
PERATION AND
S
ERVICE
M
ANUAL
20 of 85
SECTION 7: HEATER INSTALLATION
To ens u re yo u r safety and comply w ith the terms of
the w arranty, all u nits m u st be installed in
accordance w ith these instr u ctions.
The gas or the electrical s u pply lines m u st not be
u sed to s u pport the heater.
Do not locate the gas or electric s u pply lines directly
o v er the path of the fl u e prod u cts from the heater.
The heater m u st be installed in a location that is
readily accessible for ser v icing.
The heaters m u st be installed in accordance w ith
clearances to comb u stibles as indicated on the rating
plate and in this instr u ction man u al.
The minim u m and maxim u m gas inlet press u res
m u st be maintained as indicated on the rating plate.
Typical installation config u rations are sho w n
on Page 21, Figure 20 .
Expansion and contraction of the t u be dictates that
the minim u m s u spension lengths m u st be
maintained. See table on Page 21, Figure 20 .
WARNING
Severe Injury Hazard
Standard CORAYVAC ® Systems
Secure burner to combustion chamber with
nuts and lockwashers.
Hang heater with materials with a minimum
working load of 75 lbs (33 kg).
Failure to follow these instructions can result
in death, injury or property damage.
WARNING
Cut/Pinch Hazard
Wear protective gear during installation,
operation and service.
Edges are sharp.
Failure to follow these instructions can result
in injury.
WARNING
Severe Injury Hazard
CORAYVAC
®
Classic Systems
Hang heater with materials with a minimum
working load of 750 lbs. (340 kg).
Use special tube and reflector hangers when
suspending the schedule 40 steel pipe system.
Schedule 40 steel pipe is heavy and will fall if
not supported properly.
Distance between supports must be 7'-6” (2.13
m) or less.
Failure to follow these instructions can result
in death, injury or property damage.