SECTION
8
: H
EATER
I
NSTALLATION
17 of 83
SECTION
8
: HEATER INSTALLATION
To ens
u
re yo
u
r safety and comply
w
ith the terms of
the
w
arranty, all
u
nits m
u
st be installed in
accordance
w
ith these instr
u
ctions.
The gas or the electrical s
u
pply lines m
u
st not be
u
sed to s
u
pport the heater.
Do not locate the gas or electric s
u
pply lines directly
o
v
er the path of the fl
u
e prod
u
cts from the heater.
The heater m
u
st be installed in a location that is
readily accessible for ser
v
icing.
The heaters m
u
st be installed in accordance
w
ith
clearances to comb
u
stibles as indicated on the
b
u
rner control side panel (inside) and in this
instr
u
ction man
u
al.
The minim
u
m and maxim
u
m gas inlet press
u
res
m
u
st be maintained as indicated on the rating plate.
Typical installation config
u
rations are sho
w
n
Expansion and contraction of the t
u
be dictates that
the minim
u
m s
u
spension lengths m
u
st be
maintained.
See table
Install all threaded components
w
ith a minim
u
m
thread engagement of three threads. Apply s
u
fficient
amo
u
nt of high temperat
u
re anti-seize pipe
compo
u
nd (P/N 91308001 or eq
u
i
v
alent) to threads
prior to engagement. Hot compo
u
nd may drip from
threads.
WARNING
Severe Injury Hazard
Hang heater with materials with a minimum
working load of 750 lbs. (340 kg).
Use special tube and reflector hangers when
suspending the schedule 40 steel pipe system.
Schedule 40 steel pipe is heavy and will fall if
not supported properly.
Distance between supports must be 7' (2.13 m)
or less.
Failure to follow these instructions can result
in death, injury or property damage.
WARNING
Cut/Pinch Hazard
Wear protective gear during installation,
operation and service.
Edges are sharp.
Failure to follow these instructions can result
in injury.
WARNING
Burn Hazard
Pipe compound may drip during first start-up.
Protect personnel and surfaces below heater
prior to start-up.
Failure to follow these instructions can result
in injury or property damage.
Содержание CorayVac Classic SF Series
