EN
EN - 2 -
It is extremely important to read ALL safety information and instructions provided in this manual and any accompanying
documentation before installing and operating the products described herein.
Respect all cautions and warnings during installation and use of this product to avoid damage to the product and potential injury to
yourself or others.
GENERAL SAFETY INSTRUCTIONS
1
These fixtures can only be serviced by a service technician trained by Robert Juliat. Do not repair the device on your own.
Do not make changes to the device, its components, and accessories.
2. In addition to the instructions indicated on this page, relevant health and safety requirements of the appropriate EU Directives
must be adhered to at all times.
3. This fixture is in compliance with the Low Voltage Directive 2014/35/UE Standards NF EN 62368-1 : 2014, and with the EMC
Directive 2014/30/UE Standards NF EN 55103-1 : 2009 and NF EN 55103-2 : 2009.
4. Keep well away from flammable material.
5. Keep this manual for future reference.
6. Warning: battery inside, do not open.
7. This product is rated as IP20, and is for indoor use only.
INTENDED USE
8. Not for residential use.
9. This device is intended for indoor use only.
10. Every other use is not intended and could lead to injury and damage to property. Robert Juliat does not cover damages which
can result from misuse of the device.
11. Do not expose the device to rain or moisture.
12. Do not submerge the device in water.
SERVER
13. Ensure the device is mounted as per instructions on the appropriate support and stand. The stand must be stable and the
support plate must be perfectly horizontal. If it is not the case, it may fall and get damaged.
14. Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device against
damage by leaving it switched off until it has reached room temperature.
CLEANING
15. Use soft lint-free cloth only moistened with cleaning fluid. Do not use any solvent or spray cleanser. LCD monitor must be
cleaned only with specialized screen product.
AC POWER SUPPLY
16. SpotMe server requires standard AC power distribution from 90-264 VAC, 50/60 Hz.
17. Do not power a SpotMe server from a dimmed circuit, even in "Non-Dim" mode. Dimmer and non-dim modules are not suitable
sources of power because their output modifies the AC wave form. This may work for a short time, but will eventually result
in power problems, mis-operation and/or failure. Using a dimmer or non-dim module to power your Spotme server will void
the warranty.
18. Always disconnect the fixture from AC power before cleaning, removing or installing a fuse, or any part.
19. Do not use a damaged power cable.
20. Use the device only if it is in a technically perfect condition.
PLEASE NOTE
These products have been built to conform to European standards relating to professional lighting equipment. Any modification
made to our products will void the manufacturers' warranty.
1 User's instructions
