23
8.5 Switching On/Off the lamp
Press the [Mode] button in order to access the main menu. Browse through the menu by pressing the [Up] and
[Down] buttons until the display shows "LAMP". Confirm by pressing [Enter] button.
Use the [Up] and [Down] buttons to select "On" to switch On the lamp and "Off" to switch Off the lamp and
press [Enter] to confirm or [Mode] to cancel.
8.6 Test sequences
This function allows you to run a special demo-test sequences without an external controller, which will show you
some possibilities of using the SCAN 1200 XT. Press [Up] and [Down] keys to select the "Mod1" or "Mod2"
sequences. The "Mod1" is suitable for projections on the wall, ceiling or ground without any mirror-movement, the
"Mod2" uses all SCAN 1200 XT functions and therefore is good for a complete introduction of the fixture.Select
"Mod1" or "Mod2" by [Up] and [Down] buttons and press [Enter] to confirm the choice.If the test program is
running,messages "run/test" blink on the display.
If you want to pause the runnnig program in the required position, press the [Enter]-button(messages"PAUS"/"
test" blink ).To continue the program running,press the [Enter]-button again.
8.7 Stand-alone setting
This menu offers options for stand-alone mode as a selection of the playing program,programming and modifying
current programs.
