Robe ROBIN Pointe, Руководство пользователя

Страница: 31 / 48

3
1
...Another options for this command (only for Robe´s fixtures):
value PARAMETER_DATA=0x84 - lamp OFF by DMX value on DMX channel
value PARAMETER_DATA=0x88 - lamp OFF if DMX is not present
2 ...Commands relative resetable values
8. Error and information messages
Occurred errors during fixture operation are signalled by the yellow warning icon at the bottom line of the
screen:
Touch the warning icon or press the [ESCAPE] button to display error messages.
List of error and information messages:
Lamp Error
If the ignition of the lamp is 3 times unsuccessful , the display shows “Lamp Error”, meaning that the lamp could
be damaged or even missed or there could be a failure on the lamp driver.
Overheated
This message informs that the fixture had been overheated and the lamp was switched off by means of the
head temperature sensor.
Temper.Sensor Error
The message informs you that the communication betwen the head temperature sensor and the main proces-
sor failed and the lamp has been switched off.
Faulty battery
The battery on the display board is exhausted and should be replaced immediately.
Tilt Error 1 (Tilt Error 2)
This message will appear after the reset of the fixture if the head´s magnetic-indexing circuit malfunctions (sen -
sor failed or magnet is missing) or the stepping motor is defective or its driving IC on the PCB. The head is not
located in the default position after the reset.
Pan Error 1 (Pan Error 2)
This message will appear after the reset of the fixture if the yoke´s magnetic-indexing circuit malfunctions (sen -
sor failed or magnet is missing) or the stepping motor is defective or its driving IC on the PCB. The yoke is not
located in the default position after the reset of the fixture.
Colour Wheel Error 1(Colour Wheel Error 2 )
The messages will appear after the reset of the colour wheel if this wheel is not located in the default posi-
tion.
Dimmer Error 1 (Dimmer Error 2 )
The messages will appear after the reset of the dimmer/strobe module if the strobe lamellas are not located in
the default position.
Strobe 2 Error 1 (Strobe 2 Error 2 )
The messages will appear after the reset of the dimmer/strobe module if the strobe lamella is not located in
the default position.
Prism I Error 1 (Prism I Error 2 )
The messages will appear after the reset of the linear prism wheel if this effect is not located in the default
position.
Prism I Rotation Error 1 (Prism I Rotation Error 2 )
The messages will appear after the reset of the linear prism wheel if this effect is not located in the default
position.
Prism 2 Error 1 (Prism 2 Error 2 )
The messages will appear after the reset of the circular prism wheel if this effect is not located in the default