Robe Robin BMFL WashBeam, Руководство пользователя

Страница: 33 / 60

33
RDM allows explicit commands to be sent to a device and responses to be received from it.
The list of commands for Robin BMFL WashBeam is the following.
Parameter ID Discovery command SET command GET command
DISC_UNIQUE_BRANCH
*
DISC_MUTE *
DISC_UN_MUTE
*
DEVICE_INFO *
SUPPORTED_PARAMETERS *
SOFTWARE_VERSION_LABEL
*
DMX_START_ADDRESS * *
IDENTIFY_DEVICE
* *
DEVICE_MODEL_DESCRIPTION *
MANUFACTURER_LABEL
*
DEVICE_LABEL * *
SENSOR_DEFINITION *
SENSOR_VALUE
*
DISPLAY_INVERT * *
DISPLAY_LEVEL
* *
PAN_INVERT * *
TILT_INVERT
* *
DEVICE_RESET *
DMX_PERSONALITY
* *
DMX_PERSONALITY_DESCRIPTION *
STATUS_MESSAGES *
STATUS_ID_DESCRIPTION
*
LAMP_STATE * *
LAMP_ON_MODE 1
* *
DEVICE_HOURS
2
*
LAMP_HOURS 2
*
LAMP_STRIKES
2
*
ROBE_DMX_INPUT * *
ROBE_WIRELESS_UNLINK
*
1
...Another options for this command (only for Robe´s fixtures):
value PARAMETER_DATA=0x84 - lamp OFF by DMX value on DMX channel
value PARAMETER_DATA=0x88 - lamp OFF if DMX is not present
2 ...Commands relative resetable values
9. Wireless DMX operation
The wireless version of the Robin BMFL WashBeam is equipped with the Lumen Radio CRMX module and
antenna for receiving DMX signal. CRMX module operates on the .4 GHz band.
The item " Wireless " from the menu "DMX Input" allows you to activate receiving of wireless DMX (Personal -
ity--> DMX Input -->Wireless.). First two options from the "DMX Input" menu are stated in DMX chart as well
(channel Power/Special functions , range of 10-19 DMX). If DMX input option is changed by DMX command,
the change is permanently written into fixture´s memory.
DMX range of 10-19 switching fixture to the wired/wireless operation is active only during first 10 sec -
onds after switching the fixture on.
After switching the fixture on, the fixture checks both modes of receiving DMX in the following order: