Robe Fog 1550 FT, Руководство пользователя

Страница: 5 / 9

5
3. Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact.
Before beginning initial setup of your ROBE Fog Machine, make sure that there is no evident damage caused
by transportation. In the event that the unit's housing or cable is damaged, do not plug it in and do not attempt
to use it until after contacting your ROBE distributor for assistance.
4. Setup
1 . Remove all packing materials from shipping box. Check that all foam and plastic padding is removed,
especially in the nozzle area.
2. Place fog machine on a flat surface and remove fog liquid tank cap.
3 . Fill with only an original liquid recommended by ROBE distributor.
Other liquids may cause spitting and serious clogging problem and could result in the production of an un-
healthful fog. The use of other liquids voids the warranty of the Fog 1550 FT. When filled, place cap back on
liquid tank.
Firmly attach the control module cable to the connector inside the rear chamber of the machine.
WARNING:
Use of any liquid other than original liquid recommended by ROBE distributor or modification or attempted to
unauthorized repair of the Fog 1550 FT will immediately invalidate the warranty.
5. Operation
1 . The plug is at a position that is accessible when the machine in use.
2 . Plug power cord into a grounded electrical outlet. Turn power switch on rear of unit to "ON" position. Warm-
up is complete after approx. 10 minutes when the display on control module shows "Ready to Fog."
3. To emit fog, press the appropriate button on the control module for desired length of time.
4. The control unit's display will cycle "Warming up" and "Ready to Fazer" while the machine re-heats to the
proper operating temperature.
5
. When the liquid is running low, the LED inside the tank chamber starts blinking for two minutes and then
stop operation to protect the pump from running dry.
6.
For further information on operating your Fog 1550 FT, see the section titled, "Control Module Operation"
on page 6.
Caution
: "Visibility during operation is reduced"
Important!
Always monitor tank liquid level as you are fogging.
Running a fog machine with no liquid can permanently damage the unit.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the external
fuse, control module connection, and power from the wall. If all of the above appears to be O.K., plug the unit
in again. If fog does not come out after holding the button down for 0 seconds, check the hose attached
to the tank to make sure there is liquid going through the hose. If you are unable to determine the cause of
the problem, do not simply continue pushing the control module button, as this may damage the unit. Return
the machine to your ROBE distributor immediately.