3. Unpacking
Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact.Shipping carton should
contain the following items:
1.Fog 1000 FT
.Remote control
.User manual
Before beginning initial setup of your ROBE Fog Machine, make sure that there is no evident damage caused by transportation. In
the event that the unit's housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your ROBE
distributor for assistance.
4. Setup
Remove all packing materials from shipping box. Check that all foam and plastic padding is removed, especially in the nozzle area.
Place fog machine on a flat surface and remove fog liquid tank cap.
Fill with only an original liquid recommended by ROBE distributor. Other liquids may cause spitting and serious clogging problem and
could result in the production of an unhealthful fog. The use of other liquids voids the warranty of the Fog 1000 FT. When filled, place
cap back on liquid tank.
Firmly attach the remote control cable to the proper input.
WARNING:
Use of any liquid other than original liquid recommended by ROBE distributor or modification or attempted to unauthorized repair of
the Fog 1000 FT will immediately invalidate the warranty.
5. Operation
Carefully add fluid to the liquid tank.Do not overfill the tank.
Plug power cord into a grounded electrical outlet. Turn power switch on of the unit to " ON " position. The unit will take a couple of
minutes to warm up the heater. During this time the machine cannot generate fog. When the remote control is attached the green light
on the remote control will flash and stay ON when the worm-up is complete.The green light on the remote control will be blinking
when the power is "ON".
To emit fog, press the button on the remote control and hold for the desired length of time.
The Fog 1000 FT machine has opto liquid sensor. When the liquid tank is empty or during the initial usage there has not yet started
pumping the liquid, the " Err 1" will flash on display.
Caution
: "Visibility during operation is reduced"
This model can be operated at a floor level or sitting on any regular surface.
Important!
Always monitor tank liquid level as you are fogging. Running a fog machine with no
liquid can permanently damage the unit.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the external fuse, remote control
connection and power from the wall. If all of the above appears to be O.K., plug the unit again. If fog does not come out after holding
the remote button down for 30 seconds, check the hose attached to the tank to make sure there is fluid going through the hose. If you
are unable to determine the cause of the problem, do not simply continue pushing the remote button, as this may damage the unit.
Return the machine to your Robe distributor.
6. Remote control specifications
meter wired remote controller with 6, mm jack plug of Robe fog machine. When the fog machine has reached operating tempera-
ture the green light on this remote control will light up, indicating that the operator may begin fog emission by pressing the red button.
The green light flashes during fog machine warm-up and re-heating cycles (approx. 1-2 minutes), and stays ON when the machine
becomes operational. The remote controller features the “toggle switch’’ function: press once for continuous “ON”, press again to
release continuous “ON” function.
