27
- Playing program
This function allows you to run a bilt-in program "tESt" and the 3 freely-programmable programs "PrG.1,PrG.2,PrG.3"
.Press [ Up ] or [ Down ] buttons to select the desired program and press [Enter ] to run the program which will
be played continuously in a loop.
If you want to pause the runnnig program in the required position, press the [Enter ]-button(messages"PAUS"/"
program No."blink ).To continue the program running,press the [ Enter ]-button again.
Note:If the fixture operates in the controller mode ( DMX controller is connected) and any program from this
function is selected in this case the fixture will not respond to the DMX controller and will play selected program.
You can't play programs on the slave fixtures from their control panels if the master fixture is switched On and
connected to the slaves (playing is forced by the master).
- Editing program
This menu item allows you to select a program to edit or create.The ECOLOR 250 XT has one built-in program
("tESt") and the 3 free programs,each up to 99 steps.Each program step has a dynamic part(fade time) and
static part(step time).
Fade time-the time,during which effects move to the programmed position.
Step time-the time,during which effects last in the current step.
If the fixture is set as a master ,then you may edit any program in the slaves.You can't edit programs on the slave
fixtures from their control panels if the master fixture is switched on and connected to the slaves (editing is
possible by the master control panel only).
Procedure:
1. Press [ Up ] or [ Down ]-button to select the program you want to edit ("PrG.1" - "PrG.3") and press [ Enter ].
2. Press [ Up ] or [ Down ]-button to select the desired fixture ("MASt." - "SLA.9") and press [ Enter ]-button.
3. Press [ Up ] or [ Down ]-button to select the desired program step ("St.01" - "St.99") and press [Enter ]-button.
4 Press [ Up ] or [ Down ]-button to select the desired item and press [ Enter ]-button.Now you can edit by [Up
] or [ Down ] buttons the DMX value for selected item:
"P.End." -
a total number of the program steps,value 1-99 .This value you must set before start
programming(e.g. if you want to create program with the 10 steps,set the value onto 10).
"CYAn" - a cyan,value 0-255
"MAGE" - a magenta,value 0-255
"YELL" - a yellow, value 0-255
"dimr" - a dimmer intensity,value 0-255
"SPEd" - a speed of CMY and dimmer,value 0-255
"Func" - a colour macros,switch On/Off the lamp,value 0-255
"S.tim." -
a step time,value 0,1-25,5 seconds
"COPY." -
a copying the current prog. step to the next prog. step .If the last prog.step is copied to the
next prog. step ,parameter "P.End" is increased about 1 automatically (except step 99).
5. Press [ Enter ]-button to confirm adjusted value .
6. Press [ Mode ]-button,select next prog. step and repeat this procedure (steps 4 and 6).
The editting programs "PrG.1,PrG.2,PrG.3" are saved in the current modified fixture (master or slave1-9).
9.8 Reset function
Press [ ] button to run a reset. This option enables the ECOLOR 250 XT to index all effects (functions) and return
to their standard positions.
Содержание ECOLOR 250 XT
Страница 1: ......
