Robe ClubWash 250CT, Руководство пользователя

Страница: 23 / 28

3
9.9 Special functions
Use this menu for special services like adjusting lamp or adjusting effects.
MAnu.
---
Manual control of the effects
..Select this menu to call up presetted positions of the channel ef-
fects.
LA.Ad.
---
Lamp adjustment
.This function can be used when you make the fine adjustment of the lamp.If you
select this function,all effects will be canceled,shutter will be opened and the dimmer intensity will be set onto
00%.By using the options " PAn, tilt, " you can focus the light on a flat surface (wall) and perform the fine lamp
adjustment.
CodE --- Code .This function contains identification hexadecimal code (0000-FFFF) for the fixture, which is
used for the master/slave operation.
AdJ. --- Effect adjustment .By this function you can calibrate and adjust the effects to their standard/right
positions.Disconect the DMX controller from the fixture and select " AdJ. " menu.The display shows step by step
effects by which you can adjust the fixture to the required position before the function calibration(DMX controller
must be disconnected) . When the positioning is finished ,select
"F.CAL."
and press [ENTER]:
1. Calibration via the control board
Disconnect DMX controller from the fixture.Press [ENTER] and use [UP] and [DOWN] in order to display the
following item:
"Colo."
for very smooth function calibration. Press [ENTER] and use the [UP] and [DOWN] in
order to adjust its right value from 0 to 255. Then press [ENTER] to confirm or [MODE] to cancel and return
to the menu. When the calibration is finished, it is necessary to use the
"A.rES"
function in order to write the
calibration value to the memory (EPROM) and to make a reset in order to check the newly adjusted positions
of the colour wheel. When the reset of the fixture is finished, the display will show the
"F.CAL"
message. Press
[ENTER] to repeat the calibration or [MODE] to return to the
"AdJ."
menu.
2. Calibration via the external controller
Connect the DMX controller to the fixture, press [ENTER] and the [UP] and [DOWN] buttons in order to display
the following item:
"Colo."
. Select one of them and press [ENTER].
Now you can calibrate this effect by your controller. The DMX calibration protocol is described in the table
mentioned below.
DMX calibration protocol:
Effect pan/tilt resolution=16bit (16b.r.=On)
Colour wheel(smooth microstep movement) channel 1
No function channel
No function channel 3
No function channel 4
No function channel 5
No function channel 6
Standard DMX protocol:
Colour wheel channel 7
No function channel 8
Shutter channel 9
Dimmer channel 0
After having calibrated required effects, press [ENTER] to confirm (or [MODE] to cancel and return to the menu
without reset by the "A.rES." function) and use the "A.rES." function in order to write the calibration value to the
memory (EEPROM) and to make a reset in order to check the new adjusted positions of the colour wheel.