Robe 1200E Color Wash, Руководство пользователя

Страница: 31 / 38

1
Realy Skip Initial Reset?
Escape/Enter
Press [ENTER] to activate „Power down mode” without fixture reset.Now you can set features and behaviour of the fixture
by using „Fixture Address” menu and „Personality” menu.It is expected,that this mode will be exited by switching the fixture
off, but if you want to go directly to „normal operation mode”, execute any fixture reset.
Note:
All motors in „Power down mode” are deactivated and switching the lamp on from the control panel is blocked.
11. RDM
This fixture supports an RDM operation. The RDM (Remote Device Management) is a bi-directional communications protocol
for use in DMX12 control systems, it is the new open standard for DMX512 device configuration and status monitoring.
The RDM protocol allows data packets to be inserted into a DMX12 data stream without adversely affecting existing
non-RDM equipment. By using a special „Start Code,“ and by complying with the timing specifications for DMX512, the
RDM protocol allows a console or dedicated RDM controller to send commands to and receive messages from specific
moving lights.
The ROBE DreamBox with an additional ROBE RDM-network software provides the RDM functionality. The DreamBox
supports RDM - new control protocol featuring AutoPatch and Fixture Status Monitoring.
The list of RDM commands for ColorWash 1200E AT is the following:
Parameter ID Discovery command SET command GET command
DISC_UNIQUE_BRANCH *
DISC_MUTE *
DISC_UN_MUTE *
DEVICE_INFO *
SUPPORTED_PARAMETERS *
SOFTWARE_VERSION_LABEL *
DMX_START_ADDRESS * *
IDENTIFY_DEVICE
* *
DEVICE_MODEL_DESCRIPTION *
MANUFACTURER_LABEL *
DEVICE_LABEL * *
SENSOR_DEFINITION *
SENSOR_VALUE *
DISPLAY_INVERT * *
DISPLAY_LEVEL * *
PAN_INVERT * *
TILT_INVERT
* *
DEVICE_RESET *
DMX_PERSONALITY * *
DMX_PERSONALITY_DESCRIPTION *
STATUS_MESSAGES *
STATUS_ID_DESCRIPTION *
LAMP_STATE * *
LAMP_ON_MODE 1
* *
DEVICE_HOURS
2
*
LAMP_HOURS 2 *
LAMP_STRIKES
2
*
1 ...Another options for this command (only for Robe´s fixtures):
value PARAMETER_DATA=0x - lamp OFF by DMX value on DMX channel
value PARAMETER_DATA=0x - lamp OFF if DMX is not present
2
...Commands relative resetable values