8
PROGRAMMED MENU SETUP
1.
Open the door.
2.
Press and hold
‘1’
for 5 seconds. The display
will read
“PROGRAM”
.
3.
Enter the Program number to be changed -
‘0-
9’
, OR
‘00-99’
when 100 programs is enabled
using the numeral keypad.
After 2 seconds the display will show the
time associated with the program if one has
already been set.
4.
Set or adjust the cooking time using
‘0-9’
on
the
‘Numeral’
keypad.
5.
Set Power level by pressing
‘POWER LEVEL’
then select desired power using
‘0-9’
on the
‘Numeral’
keypad. Power can be set in 10%
increments.
NOTE: The microwave will operate at 100%
power if no power level is selected
STAGED PROGRAMMING
Staged cooking sequences can also be saved to
the programmed menu. A staged program will
cook in 2-3 sequential Time/Power stages.
6.
If Staged cooking is required, press
‘Time
Entry’
then repeat steps 4 and 5 for up to 3
stages.
7.
Press
‘START’
to save or
‘STOP’
to cancel.
When a staged program is run the microwave will
run through each stage automatically without user
input. The display will show total time for all
stages.
ADVANCED USER SETTINGS
1.
Open the oven door and hold number
‘2’
for 5
seconds.
“OP:—"
is displayed.
2.
Enter the number you want in relation to the
setting you want to modify. (see table below).
3.
Press the same digit again to cycle through the
available options.
E.g. To set the buzzer volume to medium. Press
‘2’
and
“OP:22”
is displayed. Each subsequent
press of
‘2’
will cycle through the options as
follows:
“OP:20”
,
“OP:21”
,
“OP:22”
,
“OP:23”
,
“OP:20”
…
4.
Press
‘START’
to save the current setting.
RESTORE FACTORY DEFAULTS
Follow the steps below to return the unit to
factory default settings. Note: all programmable
menus will be restored to default by this
procedure.
1.
In ‘Ready’ mode press and hold ‘START’ and ‘0’
together for 5 seconds, until buzzer sounds and
‘CHECK’ is displayed.
5.
The screen will display “CHECK” then ‘00’ if the
unit is not in factory default mode, and ‘11’ if
the unit is already in default factory mode.
6.
Press “START” when “00” is displayed to reset
the unit to factory default settings.
MATERIALS SUITABLE FOR USE
Items containing metal should not be used in
the microwave as they may cause sparking.
Even a small amount of metal plating on the
edge of dishes and cups can cause sparking
and should not be used.
Combustible materials such as paper should
be used with caution as they may ignite. Use
only for short cooking times and only while
attended.
Figure 2
Figure 3