6
Number Cooking Time Power Level
1
0:10
100%
2
0:20
100%
3
0:30
100%
4
0:45
100%
5
1:00
100%
6
1:30
100%
7
2:00
100%
8
3:00
100%
9
4:00
100%
0
5:00
100%
Pre-Programmed Cooking Times and Power
Level:
Note: the above programmed times and
power levels can all be changed if desired.
PROGRAMMED MENU SETUP
1.
Open the door.
2.
Press and Hold
‘1’
for 5 seconds. The display
will read
“PROGRAM”
.
3.
Enter the Program number to be changed -
‘0-9’
, OR
‘00-99’
when 100 programs is
enabled.
4.
The current cooking time is displayed, use the
‘NUMERAL’
keypad to enter a new time.
5.
Set new Power level by pressing
‘HOLD -
0%’
,
‘DEFROST – 20%’
,
‘MEDIUM - 50%’
or
‘MED-Hi - 70%’
(skip this step for 100%
power).
STAGED COOKING
Staged cooking sequences can also be saved to
the programmed menu. A staged program will
cook in 2-3 sequential Time/Power stages.
6.
If
Staged cooking
is required, press
‘TIME
ENTRY’
the display will show ‘STAGE-2’ then
repeat steps 4 and 5. Repeat for up to 3
stages.
7.
Press
‘START’
to save or
‘STOP’
to cancel.
When a staged program is run the microwave will
run through each stage automatically without user
input. The display will show total time for all
stages.
DOUBLE QUANTITY COOKING
The cooking times of programmed menus can be
adjusted for double the food quantity by pressing
‘x2’
, then pressing the desired programmed
menu number within 5 seconds. Alternatively
select the desired program the press
‘x2’.
NOTE:
The time will increase by 1.8 times the
programmed time to account for the additional
food load.
ON THE FLY COOKING
When cooking with a ‘Programed menu’, any
other ‘Pre-Programmed Menu’ can be run on the
fly by pressing the corresponding program
number. In this situation, the remaining time and
power will be updated to that of the new Pre-
Programmed menu.
SERVICE MODE
Service mode can be used to display the number
of times the door has been opened or closed.
1.
Open door, press and hold
‘3’
for 5 seconds.
“SERVICE”
is displayed.
2.
Press the number
‘3’
again to display the
number of times the door has been opened
and closed.
3.
To reset this count press number
‘4’
, then the
‘START’
button.
4.
To exit, press
‘STOP’
and close the door.
ADVANCED USER SETTINGS
User options can be changed to customize the
machine.
1.
Open the oven door.
2.
Press hold button
‘2’
for 5 seconds.
"OP:--"
is
displayed.
3.
Press the first digit of the setting you want to
modify (ref table below).
4.
Press the first digit again to cycle through the
available options. For example: To set the
buzzer volume to medium. Press
‘2’
,
"OP:22"
is displayed. Each subsequent press of the
number
‘2’
will cycle through the options
"OP:21"
,
"OP:22"
,
"OP:23"
,
“OP:20"
.
5.
Press
‘START’
to save the desired setting or
‘STOP’
to exit without saving.
