ROBAND PA100, Руководство по эксплуатации

Страница: 5 / 20

Page: 2
PACKAGING
All care is taken when packing and Roband ensures that every unit is functional and
undamaged at the time of packaging.
The Package of this Pie Warmer should include:
1) One Pie Warmer (appropriate model)
– includes shelves and crumb tray
2) This Manual
3) Packaging Materials
Any damage to the machine as a result of freight must be reported to the Freight
Company and to the agent responsible for the despatch of said unit within 24 hours of
receipt. No claims will be accepted or entertained after this period.
COMPLIANCE
Roband
®
products have been designed and manufactured to comply with any and
all specifications set out by the Australian Communications and Media Authority
(ACMA) in regards to Electromagnetic Compatibility. As testament to such
compliance these units bear the RCM symbol.
For further information contact the Australian Communications Authority, PO Box
13112, Law Courts, Melbourne VIC 8010.
INSTALLATION
Remove all the packaging materials and tape, as well as any protective plastic from
the machine. Clean off any glue residue left over from the protective plastic or tape
using methylated spirit.
Place the warmer on a firm, level surface in the required position. As a precaution, it
is recommended that all non-metal bench top surfaces be protected from heat with
some form of insulation. A piece of masonite, sheet metal, laminate or similar
material would be sufficient for this task.
Before connecting the Pie Warmer to the power supply, ensure that the thermostat
is
set to ‘0’ degrees and the on/off switch is set to the “OFF” position.
Plug the pie warmer into a standard, single phase, 10Amp power point.
National Standards exist outlining the positioning, spacing and ventilation
requirements when installing new appliances. These Standards should be
consulted and new equipment should be installed accordingly. In any situation
where specifications allow a distance of less than 100mm we would still
recommend that a well-ventilated air gap of not less than 100mm be maintained. If
the machine is near particularly heat-sensitive materials common sense should be
employed in determining sufficient distancing.