ROBAND BAIN MARIES BM14A, Руководство по эксплуатации, Страница: 6 / 16

Page: 3
INSTALLATION
Remove all the packaging materials and tape, as well as any protective plastic from
the machine. Clean off any glue residue left over from the protective plastic using
methylated spirit.
Place the Bain Marie on a firm, level surface in the required position. As a
precaution, it is recommended that all non-metal bench top surfaces be protected
from heat with some form of insulation. A piece of masonite, sheet metal, laminate or
similar material would be sufficient for this task.
Before connecting the Bain Marie to the power supply, ensure that all the controls are
in the "OFF" position.
Plug the machine into a power outlet matching the plug type supplied.
National Standards exist outlining the positioning, spacing and ventilation
requirements when installing new appliances. These Standards should be
consulted and new equipment should be installed accordingly. In any situation
where specifications allow a distance of less than 100mm we would still
recommend that a well-ventilated air gap of not less than 100mm be maintained. If
the machine is near particularly heat-sensitive materials common sense should be
employed in determining sufficient distancing.