Robam JZT-G370, Руководство пользователя

Страница: 9 / 12

7
Gas Hob
8. When the copper cover is placed, the positioning rod is inserted into the positioning hole on the burner seat
and is placed in place to ensure that it is not moved.
Positioning rod
Positioning hole
Bottom functional location diagram
1. Be sure the copper core, copper cover and pan stand in right position. Check the switch first before turn on
the valve of the gas. (Pic1)
2. IGNITION METHOD: Push the switch and turn to 90 degrees anti-clockwise for the strongest flame, (Pic2)
meanwhile the poop sound of pulse firing can be heard. The full push should be taken for 3-5 seconds till the
flame comes out. Otherwise, the same operation above should be retaken. In addition, push the switch and turn
to 90 degrees anti-clockwise again is the smallest flame. (Pic3)
Remark: The device shall not be operated for more than 15 s. If after 15 s the burner has not lit, stop operating
the device and open the compartment, door and/or wait at least 1 min before attempting a further ignition of the
burner.
Use Instruction
REMARKS: The first ignition or that of the first reuse of the gas stove may not work immediately, because there
is air in the tube, it needs to be operated repeatedly.
3. SWITCH-OFF: Turn the switch to the position clockwise (Pic1) and the fire will be switched off.
4. FIREPOWER CONTROL: Operate according to the instruction mark.
5. Airflow control: Please adjust the inlet airflow, to make the gas fully fired.
Adjust the inlet spot nail or plate (at the bottom of hobs), by clockwise or anti clockwise, till the flame become
stable and blued colored (as following picture). Here is the way to differ the combustion states:
swtich off position
Pic1
strongest
flame position
Pic2
weakest flame position
Pic3
Battery installation position
The position of the air inlet of the stove