Waste Water Tank Dumping:
To dump the exterior black waste water tank:
1.
Turn the battery disconnect switch to the “ON”
position, if not already on, (located on the
monitor panel).
2.
Remove the sewage discharge hose from storage,
(see Picture G-P12).
3.
Insert the discharge outlet into the waste
receptacle.
4.
Open the valve on the sewage hose,
(see Picture G-P12).
5.
Open the black water tank gate valve by pulling
the gate valve handle out, (black water tank gate
valve has a black handle), (see Picture G-P9).
6.
Open the driver’s door, press and hold the macerator
pump, (red) button until the tank is empty,
(see Picture G-P11).
To dump the grey waste water tank:
1.
Open the grey water tank gate valve
(grey water tank gate valve has a grey handle).
2.
Open the driver's door, press and hold the
macerator pump, (red) button until the grey waste
tank is empty, (see picture G-P11).
3.
Close all the gate valve handles by pushing them in
to there original position..
4.
Close the sewage discharge valve on the end of
the sewage hose.
5.
Return the sewage hose to its storage
compartment.
6.
Turn battery disconnect to the “OFF” position.
NOTE:
It is recommended to always dump the black
water tank first, then the grey water tank to flush
out the sewage discharge system.
NOTE:
If the macerator should get clogged, you will
have to push and turn the manual macerator
crank handle to dislodge any debris that might
be blocking the macerator, (see picture G-P10).
WATER SYSTEMS
D
Do
occ N
No
o::
21906540-RSAD
R
Re
ev
v::
01
C
Co
op
py
yrriig
gh
htt ©
© H
Ha
an
nm
ma
arr M
Mo
otto
orr C
Co
orrp
po
orra
attiio
on
n 2
20
00
06
6
G
G--5
5
Picture G-P11:
Macerator pump switch located at
the base of the driver seat pedestal (red button) .
Picture G-P12:
Sewage discharge hose storage
located in driver's side storage drawer.
Picture G-P10:
Macerator manual crank handle
located to the right of the waste holding tanks gate
valve handles.
