Roadstar RCR-4625U, Руководство пользователя

Страница: 5 / 42

2 English
 OBJECT AND LIQUID ENTRY - Care should be taken so that objects do not fall
and liquids are not spilled into the enclosure through openings.

DAMAGE REQUIRING SERVICE
The appliance should be serviced by qualified service personnel when:
- The power supply cord or plug has been damaged;
- Objects have fallen into or liquids has been spilled into the radio;
- The appliance has been exposed to rain;
- The appliance has been dropped or the enclosure damaged;
- The appliance does not appear to operate normally.

SERVICING - The user should not attempt to service the appliance beyond that
descrive in the user operating instructions. All the servicing should be referred to
qualified service personnel
Note: If the display does not function properly or no reaction to operation of
any control may due to the electrostatic discharge. Switch off and disconnect the AC
cord and remove all the batteries, then turn the power back on after a few seconds.
POWER SOURCES
AC POWER: You can power your portable stereo system by plugging the AC po-
wer cord into the AC plug (22) at the back of the unit and into a wall AC power outlet.
Check that the rated voltage of your appliance matches your local voltage.
Make sure that the AC power cord is fully inserted into the appliance.
BATTERY POWER: To use the radio with batteries, disconnect the AC power cord
and insert 4 × “LR14” batteries into the compartment (19).
Be sure that the batteries are inserted correctly to avoid damage to the appliance.
Remove the batteries when the radio will not be used for a long period of time, as this
will cause leakage to the batteries and subsequently damage to your radio.
RADIO OPERATION
1. Set the function selector (12) to “RADIO” mode.
2. Select desired band by using the band selector (14).
3. Adjust radio frequency to your desired station by using the tuning control (15).
4. Adjust the volume control (13) to the desired level.
Note: For a better reception, reorient the antenna (11).
TAPE OPERATION
1. Set the function selector (12) to “TAPE” mode.
2. Press STOP/EJECT (18.2) to open the cassette door (10) and insert your tape.
3. Close the cassette door (10).
4. Press PLAY (18.5) to start playing tape.
5. Adjust the volume control (13) to the desired level.
 Press PAUSE (18.1) when you want to stop playing tape operation temporarily,
press again to resume tape operation.

Press STOP/EJECT (18.2) when finished, press again to open the cassette door.
 Press F.FWD (18.3) or RWD (18.4) to start rapid tape winding either forward or
reverse direction.