Page 3 of 6
Option
#1. (Fig. 2)
Position the front mounting feet as far forward as possible. Bolt head will be approximately 3/4"
from the cab of the truck. Determine which pre-drilled hole falls over the stake pocket. If none of
the pre-drilled holes fall over the stake pocket, mark and drill a hole in the mounting foot that is
approximately over the center of the stake pocket. Put bolt
(J)
along with flat washer
(G)
through
the mounting foot and start T-nut
(H)
as shown in figure 2. Maneuver the T Nut
(H)
inside the
stake pocket, and tighten it up against the underside of the bed rail. Secure the rear of the front
mounting foot to the bedrail using Bolt
(C)
along with flat washers
(G)
, lock washer
(D)
and nut
(A)
.
Option
#2 (Fig. 3)
Position the front mounting feet as far forward as possible. Bolt head will be approximately 3/4"
from the cab of the truck. Secure the rear of the front mounting foot to the bedrail using Bolt
(I)
and side angle bracket
(Q)
as shown. Use a pre-drilled hole in the top of each mounting foot or
drill an additional hole if needed. Drill a 3/8" hole through the bed rail and install bolt
(C)
along
with flat washer
(G)
, lock washer
(D)
and nut
(A)
.
