Roadmaster VR500CS-BT, Руководство пользователя

Страница: 15 / 22

RADIO OPERATION
1. Choose Radio Band
Press the BND•ID3 Button anytime to ac-
cess the radio function.
The unit comes with five bands - three FM
(FM1, FM2, and FM3) and two AM (AM1 and
AM2) Band selects. Each of the five bands
can store up to six preset stations, for a to-
tal of 30 preset memory stations.
NOTE: To change the receiving range from
USA to Europe, remove the faceplate and
move the switch marked “A-E” to the ap-
propriate region.
2. Radio Tune / Seek Function
In Radio Mode, press Seek +/- Button to
manually adjust the radio frequency.
3. SEEK 1 & SEEK 2
Press and hold the Volume Knob until “DSP
OFF” is shown on the LCD, then press the
Volume Knob to cycle through the menu se-
lections until “SEEK 1” is shown. Use the
Volume Knob to select either “SEEK 1” or
“SEEK 2”.
A. Seek 1
Press and hold the |<< or >>| Button for
more than 1 second. The radio will seek the
next strong and clear frequency station. Re-
peat to seek more stations in your listening
area with a strong signal.
B. Seek 2
Press and hold the |<< or >>| Button for
a radio station search. The search will not
cease until you release the button.
4. Mono/Stereo Reception Control
In FM radio mode, press the 0/ST button
on the front panel or on the remote control
to toggle between mono reception or stereo
reception. The display will show “MONO” or
“STEREO”.
Improvement of reception of distant sta-
tions can be done by selecting “MONO”
operation which may cut down some re-
ception noise.
5. Save Your Preset Stations
There are six numbered preset buttons
which can store and recall stations for each
band. While listening to a radio station, press
and hold one of the buttons numbered 1-6
until you hear a beep. That button is now
the pre-set button for that station.
6. Automatic Store/Preset Scan
A. Automatic Scan & Store
While listening to the FM Radio, press and
hold the F/PS Button for more than 3 sec-
onds. The receiver will automatically scan
and save stations to one of the FM Bands.
While listening to the AM Radio, press and
hold the F/PS Button for more than 3 sec-
onds. The receiver will automatically scan
and save stations to one of the AM Bands.
B. Reset Automatic Scan & Store
Press and hold the F/PS button for 3 sec-
onds and the receiver will scan the radio
stations in your area, then save them over
the current pre-sets.
C. Scan Saved Stations
Press the F/PS Button once to scan all sta-
tions saved. In the FM Mode, all 3 FM Bands
will be scanned. In the AM Mode both of the
AM Bands will be scanned.
14