Roadmaster RM-MD911, Руководство пользователя

Страница: 11 / 13

1)Decide upon system configuration and options that will be installed.
2)Review all manuals to become familiar with electrical requirements and hook ups
3)Decide upon mounting location of all components and method of mounting
4)Prep the vehicle by removing any interior trim necessary to gain access to vehicles
wiring as well as all areas wher interconnecting wire harnesses will need to be located.
If any access holes need to be cut into the vehicle, this should be done now as well .
5)Route the wiring harnesses throughout the vehicle as necessary.(Refer to the wiring
Diagrams on this manual as well as the wiring instructions for the individual
components and accessory options being installed). Be sure that all wiring is protected
from sharp edges and is routed in such a manner that pinched when all components and
interior trim are fully installed. Be sure to leave enough slack in the wiring at each
component to allow working room
6)Remove all A/V system components form their packaging and place them loosely in the
vehicle at their respective locations.
7)Connect all components together and verify proper operation of all system functions.
Note: This is best done BEFORE , components have been permanently mounted .
8)After verifying proper operation of the system , proceed to mount of each component
9)When all components are mounted , recheck function of entire system again to ensure
that no wiring was pinched or connected improperly during final installation..
GENERAL INSTALLATION APPROACH GENERAL INSTALLATION APPROACH
18
17