RoadHog RH48200, Руководство пользователя

Страница: 13 / 63

13
STARTING PROCEDURE- USING MASTER PANEL ON ROADHOG
(continued)
This procedure requires another operator at ground level.
Water Kit Control
1. Once the engine is started.
2. Press “water kit button” button on master panel once to start the pump. (Button will flash
green when on)
3. Press “water kit button”
button on master panel twice to activate slave to clutch.
(Button will be solid amber when in auto)
4. Press “water kit button”
button on master panel three times to stop the pump. (Button will
be solid green when off)
Fully lower the loader arms and then roll out the bucket function until the planer skis are level with
the pavement.
Move the throttle to the full rpm position. and keep it there during the milling operations. Begin the
operation by setting the depth cylinders to zero depth at the depth gauge. Lower the drum into the
cut to the desired depth. Move forward at a speed that will allow the drum to mill or cut efficiently
without stalling.
NOTE. Milling speed will depend on tooth condition, age and density of the material, aggregate
size and ambient temperature.