2018 Jeep Wrangler JL Rear Bumper
Page ( 3 of 4 )
www.
ROADARMOR
.com
INSTALL INSTRUCTIONS
1
Disconnect the rear bumper harness, release the clips holding the bumper end of the harness to the Jeep. Connector is
located inside the driver side hitch of the Jeep. Remove hitch harness and plug from bumper.
2
Using a 16mm socket, remove license plate and 2 bolts securing the center of bumper to hitch.
3
Using a 16mm socket, remove 2 bolts securing the bumper outer mounting brackets to the rear hitch from ea. side.
4
Pull off factory bumper and set aside.
5
Remove factory recovery hook using 21mm socket; 2 bolts on the top, through the hitch.
2
3
3
NOTE
5
6
If equipped, disassemble rear bumper, carefully remove all sensors and harnesses. **Note sensor location**
IF INSTALLING REAR WINCH—CONTINUE WITH install STEP 5 Below
-
TECH Tips on Last Page
STOP
1
Install Road Armor Logo with included #10 Stainless Button Head Bolts and Keps Nuts.
2
Install both 3x2 (
SRM SURFACE MOUNT
) lights, as this is easier now than after Road Armor bumper has been installed.
3
Install hitch pin plate with included #10 Stainless Button Head Bolts and Keps Nuts
4
Install both license plate lights using #8 hardware, as this is easier now than after Road Armor bumper has been installed.
NOTE
If installing winch do so at this time: Install 8000lbs Winch on to winch plate.(License Plate Relocation Bracket:
LPF360B
)
**DISASSEMBLY COMPLETE**
STOP
