www.ro-man.com
T: 01823698813
Installation
1 - Remove filters from packaging
2 - Insert the new filter cartridge into the housing.
3 - Ensuring the O ring is in place, screw the filter housng back into the cap.
4 - Do not over tighten.
5 - Connect the water supply using the mains pipe clamp. (See last Page)
6 - Turn on the water supply.
7 - Check for air traps if there relase and check for leaks.
8 - Flush 40lt of water through your system and discard this water.
9 - Set the flow control valve to no more than 2 gallons per minute. We recommend you
allow the water as mush contact time as possible with your purifier.
10 - Securely mount your system using the bracket provided, if you do not intend
permanently mount your system ensure it is securely placed where it will not fall and break.
11 - Thoroughly check your system for any leaks.
Precautions
It is important to protect your system from frost and low temperatures. As water expands
when frozen this can cause numerous problems with your system including cracked pods.
Once the filters in your system have been wet they should not be allowed to dry out. If the
filters do dry please replace them.
We recommend that filters should be replaced every six months to ensure your purification
is working to the highest capacity
Further Support
If you experience problems or require additional help please contact our support team
Mains Pipe
Clamp
Flow
Control
Valve
Filter
Filter
Outlet
