Sm artW inch U ser G uide page 10
8.
Drive winch out (using TX stick) till the main boom is at the
desired fully sheeted out position. With the winch in this
position, pause for at least one second without moving the
winch, then remove RX plug.
Three beeps indicates that the new travel setting is stored. If you do not wish to
make any changes to your battery monitoring settings, switch winch off now and
setup is complete.
Or if you wish to change the existing battery monitoring settings then perform
either step 9a or 9b.
9a
To enable battery monitoring, push plug into RX and wait till you
hear either 1, 2 or 3 quick beeps.
Battery must be fully
charged
for correct detection of number of cells.
9b
To disable battery monitoring, push plug into RX and
immediately pull it out again (within about 1 second).
If three rising tones have sounded, 9b was performed and battery monitoring is
now off. If 1, 2 or 3 quick beeps were heard then step 9a was performed and
battery monitoring is turned on. The number of beeps corresponds to the battery
monitoring level set. See table 1.
Once setup is complete, the winch must be switched off.
12. Adjusting Dec Rate, Scaled Linear Travel, Speed & Dead Band
For a description of these features, see page 2. Each of these settings has a
separate entry point and can be adjusted independently. For optimum setting of
these features it is important to already have the
SmartWinch
set for TX end
points. However setting end points does not need to be done each time one of
these adjustments is made.
For each setting, start with;
SmartWinch
turned
off
, TX turned
on
, TX trim set to
minimum
, RX lead plug
out
of RX and TX stick in desired position. For each
adjustment, select close hauled for minimum, full out for maximum or an
intermediate position as desired. Note that the
SmartWinch
will not drive while
making these adjustments. There is no need to remove drum or sheets.
