RMG NETWORKS IVS SDA-909, Монтаж, электрическое подключение, регулировка

Страница: 14 / 24

14
Step-by-Step Connections for the IVS SDA-909
Warning: Failure to set up your IVS SDA-909 sequentially according to the steps below
may cause configuration difficulties or loss of functionality.
Refer to
Figure 4 on page 12
for the following connections:
1. Insert a standard Ethernet cable into the Ethernet port (
12
).
2. The IVS SDA-909 supports one HDMI-to-HDMI output connection.
Connect the male end of an HDMI-to-HDMI cable (not supplied) to an HDMI
connector (
11
) at the back of the IVS SDA-909. Connect the other end of the cable
to an HDMI connector on a display device.
3. Connect the female end of the power cord to the three-prong connection at the
back of the IVS SDA-909
(6
). Plug the other end of the power cord into a standard
AC outlet.
4. Briefly press the power button (
4
) on the IVS SDA-909. The SDA welcome
message appears on the output screen.
Note: The first time you connect your SDA, the message “One Moment Please”
may appear on the video display. Depending on your network, this message might
appear for up to one minute. After that time a “Welcome” screen appears that
displays the name of the SDA, its serial number, and the IP address that you'll need
to set up your SDA. Use this IP address to access the Web Interface.
5. Refer to the following SDA configuration guide to configure your IVS SDA-909:
http://support.rmgnetworks.com/documentation/IVS_SDA_Configuration_v12.0.2.pdf