RM RM-5777, Инструкция и руководство пользователя

Страница: 5 / 16

INSTALLATION
The installation scenario described in this manual
assumes that you have a typical car.
If your specific car requires any adjustments or
modifications , consult your nearest DELOS car
audio dealer.
PRECAUTIONS
This unit is designed for negative - ground,
12-V DC operation only.
Before starting installation , make sure the
ignition switch is set to OFF and disconnect the
ground terminal of the car battery to avoid short-
circuiting.
Install the unit where it will not injure the opera-
tion of the vehicle.
Install the unit where it will not injure the passen-
ger if where is a sudden stop, like an emergency
stop.
Avoid installing the unit where it would be subject
to high temperatures caused by direct sunlight
or hot air from the heater, or where it would be
subject to dust, dirt or excessive vibration
Use only the supplied mounding hardware for a
safe and secure installation.
REINSTALLATIONS
FRONT PANEL INSTALLATION
BASIC INSTALLATION
If there is installation hardware for another
receiver already in the dashboard, it must be
removed. Before installing the unit in the dash-
board, Remove the trim plate from the unit. Then,
please remove the screws( )on the top of unit.
Store the detachable in its protective case for
safe keeping. To drop / take away / install and
recover front panel, see the picture.
Mounting-angle adjustment
The mounting angle should be 30 degrees or
less from horizontal.
Caution on installation without using the sleeve
Be sure to use the screws( )attach the mounting
brackets. (Not supplied).
Note that the installation show is a typical
example.
For some car types you may need to make
adjustments or modification to make adjustments
or modification to install the unit. F your car is of
such type, consult you nearest DELOS car audio
dealer.
4
a
3
1 2
A
B
B
C
1
2
A
4
3
a
C
DETACHABLE
FACEPLATE
INSTALL BRACKET
CONSOLE
B
Page27
b
b
a
a
c
c
F
F
F
E
E
A
A
B
B
B
C
C
C
D
D
d
d
+ + + +
+ + + +
- -
- -
- - - -
- -
Grey
White
Grey/black
White/black
GROUND
(ACC)
(AUTO ANT)
(BACK UP B )
Black
Red
Blue
POWER ANTENNA
IGNITION
Pink (POWER AMP)
CONTROL
RELAY
BATTERY
1A
15A
Yellow
Violet/Black
Green/Black
Violet Green
+ +
+ +
L L
R R
+ + + +
+ + + +
- -
- -
- - - -
- - - -
+ +
+ +
L L
R R
+ +
+ +
- -
- -
- -
- -
+ +
+ +
L L
R R
+ +
+ +
- -
- -
- -
- -
+ +
+ +
L L
R R
+ +
+ +
- -
- -
- -
- -
CONNECTIONS
PRECAUTIONS
PRECAUTION ON MAKING CONNECTIONS
Before connecting, make sure that the ignition switch
is set to OFF. And remove the ground terminal of the
battery to protect the unit and your car from damage.
Caution
make the connection correctly, as illustrated in the
connection diagram. Do not connect the negative
cord of each speaker wire to a common point.
When replacing the fuse. Be sure to use a fuse of the
same rated amperage.
Use of a fuse of a higher rating may cause serious
damage to the unit.
One or more of the connectors , and may
not exist on the model your chased. Make the
appropriate connection or connections according
to the configuration of your unit.
See the section
“SPECIFICATIONS” of the
separate Operating Instructions.
From the car antenna
VIDEO OUT
To the out per jack of the optional power
amplifier (Line out)Colors of leads
Aux in
To the wiring of the vehicle colors of leads
Note
lies speakers with an impedance of 4 to 8 ohms and
with adequate power handing capacities. Otherwise,
the speakers may be damaged.
Do not connect the speakers in parallel.
Do not connect the terminal of the speaker system to
the car chassis.
4-SPEAKER CONNECTIONS
Black (ground lead to be connected to
vehicle <metal> boby.)
Red (ACC lead to be connected to the terminal
from which power is supplied when the ignition
switch is set to AC.)
Yellow (battery lead to be connected to the
backup terminal of the which power is supplied.)
Blue (power antenna lead to be connected to the
terminal of the control
This lead is not used for a vehicle with a manual
antenna or a switch operated
power antenna. If you will use the optional power
amplifier with the unit, connect this lead to the
remote terminal of the amplifier.)
Pink (Power amp remote control)
CONNECTION DIAGRAM
+