RM Mobile One 945, Руководство пользователя

Страница: 38 / 53

Error Messages During Start-up
If a non-fatal error is detected during start-up (i.e. an error which
does not prevent the system from starting up), an error message
is displayed on your screen. Note the error message and then
press <F1> to continue. This section lists some of the error
messages which are displayed and suggests how to correct the
error using the Setup program. There may also be some error
message codes in the System board User Manual (if supplied).
If an error message is displayed on the screen, which is not listed,
contact RM for further information on the error which has been
detected.
If the POST (Power On Self Tests) detect a fatal error during start-
up (i.e. an error which will not allow the system to continue the
start-up procedure), your notebook has developed a serious
problem and you should contact RM for assistance. Fatal errors
are usually communicated through a series of audible beeps. Note,
however, that some notebooks always beep when the BIOS System
Configuration screen is displayed to signal that the POST routines
are finished.
Cache Memory Bad, Do Not Enable Cache!
The external cache memory is defective.
CMOS Battery State Low
The battery in your system, which provides power to CMOS to store
the system settings, is low in power and needs to be changed or
recharged (depending on the battery type). Leave the notebook
switched on for 48 hours to recharge the battery.
CMOS Checksum Failure
When you save changes made in Setup and exit the Setup
program, a checksum value is generated. This value is stored and
used for error checking. If this stored value is different from the
value determined by the POST routines during start-up, the CMOS
Checksum Failure error message is displayed. Change the Setup to
the optimal settings then change any additional variances according
to the model of notebook (see page 61 for details on the Setup