Installation Manual
Neutrino LED Headlights with Halo
Vehicle Can-Am Renegade Gen 2 2012-2019
Also fits Maverick 1000R & Renegade Gen 1 2008-2012 Rev: 2.0
Page 02
Make sure that you clean your bike carefully especially around
the factory headlights to get off as much dirt as possible. We
also recommend that you clean all the factory parts you remove
before starting installation of the new Neutrino LED headlights.
Same procedure on both right and left side Partial of this manu-
al shows an OE plastic front not installed on a vehicle just to
make it easier to see all the parts that have to be removed and
installed during the process.
Lets start the process!
Remove the OE contacts from the Halogen factory bulbs before
starting removing the factory headlights. Mark wich connector is
high and low beam on the OE connectors/cables.
NOTE HEADLIGHT FRAME IN THE
MANUAL IS THE RIGHT SIDE
(SEEN FROM THE DRIVERS SEAT)
Remove the black sticker that
is covering this bolt hole we
have sent new replacement
RJWC stickers with the hard-
ware kit so you can throw the
OE ones in the trash, Remove
the bolt and nut.
