RJG Lynx LS-B-127-125, Руководство по эксплуатации продукта

Страница: 21 / 66

Product Manual | Lynx™ Strain Gage Button Sensors LS‑B‑127‑50/125/500/2000 RJG, Inc. 13
INSTALLATION SPECIFICATIONS ( continued )
3.
Ejector Pin Head Pocket
Machine a pocket for the ejector pin head in the
ejector retainer plate that is equal to the ejector
pin head DIA
plus 0.02” (0,5 mm [
1
at right ])
MIN per side.
Allow clearance above the ejector pin head.
If the part thickness is < 0.05” (1,5 mm),
the clearance should equal 20% of the part
thickness. If the part thickness is > 0.05”
(1,5 mm), the clearance should equal 0.01”
(0,3 mm [
2 i
at right ]).
NOTE Ejector pin head clearance not to
exceed 20% (1/5th) of part thickness at point of
pin/part convergence.
Chamfer the lead‑in edge 45° (
3
at right
)—
refer to the following table for chamfer length.
CHAMFER LENGTH
Ejector Pin DIA Chamfer Length
0.04–0.08 (1,0–2,0 mm) 0.01 (0,3 mm)
0.10–0.20 (2,5–5,0 mm) 0.02 (0,4 mm)
0.24–0.40 (6,0–10,0 mm) 0.025 (0,6 mm)
Fit the ejector pin with an H7/g6 standard fit
(
4
at right).
Counterbore the ejector pin head pocket into
the ejector plate 0.01” (0,3 mm [
5
at right ])
MIN deep, by ejector pin head DIA + 0.04”
(1,0 mm [
6
at right ]).
1
2
3
4
5
6
1
0.02” (0,5 mm) MIN per side
2 20% part thickness if < 0.05” (1,5 mm), 0.01” (0,3 mm) if part thickness > 0.05” (1,5 mm) i
3
45° Chamfer, refer to table for chamfer length
4
H7/g6 standard fit
5
0.01” (0,3 mm) MIN
6
ejector pin head DIA + 0.04” (1,0 mm)
CAUTION
Transfer pin applications require
guided ejection; failure to comply may result in
damage to or destruction of components.
CLAMP PLATE (TYPICAL) INSTALLATION